IEEE 111 : 2000

Table of Contents

1 Scope
  1.1 General
  1.2 Typical types of transformer to which this standard
      applies
2 References
3 Definitions
4 Symbols
5 Performance tests
  5.1 Electrical tests (not recorded)
  5.2 Electrical tests (recorded)
6 Marking
  6.1 Nameplate markings
  6.2 Terminal markings
7 Service conditions
8 Computations
9 Tests methods
  9.1 Temperature rise tests
  9.2 Balance tests
  9.3 Computations
  9.4 Measurement of open-circuit and short-circuit
      inductance and resistance
  9.5 Terminated impedance measurement
Annex A (informative) Definitions and discussion
Annex B (informative) Recommended practice for making
         electrical tests
Annex C (informative) Service conditions
Annex D (informative) Methods of computing time delay from
         phase shift measurements

Abstract

Describes electronics wideband transformers transmitting power within wide band of frequencies covering at least one decade in frequency spectrum. Includes data for design of feedback amplifiers and control networks or other circuits in which knowledge of amplitude and phase-frequency response needed.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Institute of Electrical & Electronics Engineers
Pages
ISBN
Supersedes	IEEE DRAFT 111 : 1998